| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| No cwe for this issue in Microsoft Office SharePoint allows an authorized attacker to elevate privileges over a network. |
| Improper validation of specified type of input in .NET Framework allows an unauthorized attacker to perform tampering over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
af_unix: Reject SIOCATMARK on non-stream sockets
SIOCATMARK reports whether the receive queue is at the urgent mark for
MSG_OOB.
In AF_UNIX, MSG_OOB is supported only for SOCK_STREAM sockets.
SOCK_DGRAM and SOCK_SEQPACKET reject MSG_OOB in sendmsg() and recvmsg(),
so they should not support SIOCATMARK either.
Return -EOPNOTSUPP for non-stream sockets before checking the receive
queue. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ctnetlink: use netlink policy range checks
Replace manual range and mask validations with netlink policy
annotations in ctnetlink code paths, so that the netlink core rejects
invalid values early and can generate extack errors.
- CTA_PROTOINFO_TCP_STATE: reject values > TCP_CONNTRACK_SYN_SENT2 at
policy level, removing the manual >= TCP_CONNTRACK_MAX check.
- CTA_PROTOINFO_TCP_WSCALE_ORIGINAL/REPLY: reject values > TCP_MAX_WSCALE
(14). The normal TCP option parsing path already clamps to this value,
but the ctnetlink path accepted 0-255, causing undefined behavior when
used as a u32 shift count.
- CTA_FILTER_ORIG_FLAGS/REPLY_FLAGS: use NLA_POLICY_MASK with
CTA_FILTER_F_ALL, removing the manual mask checks.
- CTA_EXPECT_FLAGS: use NLA_POLICY_MASK with NF_CT_EXPECT_MASK, adding
a new mask define grouping all valid expect flags.
Extracted from a broader nf-next patch by Florian Westphal, scoped to
ctnetlink for the fixes tree. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: x_tables: restrict xt_check_match/xt_check_target extensions for NFPROTO_ARP
Weiming Shi says:
xt_match and xt_target structs registered with NFPROTO_UNSPEC can be
loaded by any protocol family through nft_compat. When such a
match/target sets .hooks to restrict which hooks it may run on, the
bitmask uses NF_INET_* constants. This is only correct for families
whose hook layout matches NF_INET_*: IPv4, IPv6, INET, and bridge
all share the same five hooks (PRE_ROUTING ... POST_ROUTING).
ARP only has three hooks (IN=0, OUT=1, FORWARD=2) with different
semantics. Because NF_ARP_OUT == 1 == NF_INET_LOCAL_IN, the .hooks
validation silently passes for the wrong reasons, allowing matches to
run on ARP chains where the hook assumptions (e.g. state->in being
set on input hooks) do not hold. This leads to NULL pointer
dereferences; xt_devgroup is one concrete example:
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000044: 0000 [#1] SMP KASAN NOPTI
KASAN: null-ptr-deref in range [0x0000000000000220-0x0000000000000227]
RIP: 0010:devgroup_mt+0xff/0x350
Call Trace:
<TASK>
nft_match_eval (net/netfilter/nft_compat.c:407)
nft_do_chain (net/netfilter/nf_tables_core.c:285)
nft_do_chain_arp (net/netfilter/nft_chain_filter.c:61)
nf_hook_slow (net/netfilter/core.c:623)
arp_xmit (net/ipv4/arp.c:666)
</TASK>
Kernel panic - not syncing: Fatal exception in interrupt
Fix it by restricting arptables to NFPROTO_ARP extensions only.
Note that arptables-legacy only supports:
- arpt_CLASSIFY
- arpt_mangle
- arpt_MARK
that provide explicit NFPROTO_ARP match/target declarations. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: validate USB endpoints
The kalmia driver should validate that the device it is probing has the
proper number and types of USB endpoints it is expecting before it binds
to it. If a malicious device were to not have the same urbs the driver
will crash later on when it blindly accesses these endpoints. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Use correct version for UAC3 header validation
The entry of the validators table for UAC3 AC header descriptor is
defined with the wrong protocol version UAC_VERSION_2, while it should
have been UAC_VERSION_3. This results in the validator never matching
for actual UAC3 devices (protocol == UAC_VERSION_3), causing their
header descriptors to bypass validation entirely. A malicious USB
device presenting a truncated UAC3 header could exploit this to cause
out-of-bounds reads when the driver later accesses unvalidated
descriptor fields.
The bug was introduced in the same commit as the recently fixed UAC3
feature unit sub-type typo, and appears to be from the same copy-paste
error when the UAC3 section was created from the UAC2 section. |
| Dell Secure Connect Gateway (SCG) Policy Manager, versions prior to 5.34.00.16, contains an Improper Validation of Specified Type of Input vulnerability. A low privileged attacker with remote access could potentially exploit this vulnerability, leading to Information exposure and Information tampering. |
| fast-jwt provides fast JSON Web Token (JWT) implementation. Prior to 6.3.0, fast-jwt createVerifier accepts a validly signed JWT whose payload is a JSON array because src/decoder.js checks that the payload is an object but does not reject arrays. The claim validator loop then finds no named exp, nbf, iss, aud, sub, jti, or nonce properties and silently skips those configured checks, returning the array as a successfully verified payload. An attacker who can produce or influence a validly signed token may bypass expiry, issuer, audience, subject, revocation, and replay protections. The opt-in requiredClaims option can block missing claims, and signature verification itself is not bypassed. This issue is fixed in version 6.3.0. |
| Mattermost Desktop App versions <=6.2 6.2.2.0 fail to validate the URL scheme when checking whether a target URL is internal to the connected server, which allows a network-positioned attacker to load a plugin popout window over an insecure connection via a link using a downgraded URL scheme. Mattermost Advisory ID: MMSA-2026-00717 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: don't offload TC setup on AP_VLAN interfaces
AP_VLAN interfaces are purely virtual, so don't try to offload
TC setup to drivers. We can't really use the AP interface either
since we may not know it all the time, and it could technically
even change.
Just reject the TC offload so things get done in software. |
| A flaw was found in Keycloak. Keycloak's Security Assertion Markup Language (SAML) broker endpoint does not properly validate encrypted assertions when the overall SAML response is not signed. An attacker with a valid signed SAML assertion can exploit this by crafting a malicious SAML response. This allows the attacker to inject an encrypted assertion for an arbitrary principal, leading to unauthorized access and potential information disclosure. |
| `_nx_icmpv6_validate_options()` scans the option area with `while (length > 2)` (`common/src/nx_icmpv6_validate_options.c:79`). An area whose size leaves a one- or two-byte residue exits the loop with that tail unexamined; the residue is not negative, so the function returns `NX_SUCCESS`. Its zero-length rejection never sees those bytes.
Every consumer then re-walks the same area, reading a two-byte option header at the residue and subtracting `nx_icmpv6_option_length << 3` with no zero check and no remaining-length check. Three outcomes follow, selected by bytes the attacker controls.
**Zero length byte.** The walker subtracts zero and advances zero. All four handlers loop forever — `_nx_icmpv6_process_ra` (`nx_icmpv6_process_ra.c:245, :528`), `_nx_icmpv6_process_ns` (`:251, :329`), `_nx_icmpv6_process_na` (`:147, :156`) and `_nx_icmpv6_process_redirect` (`:247, :350`). The walk runs in the IP thread, which is the highest-priority thread and does not yield inside the loop, so the system stops until a watchdog reset and the frame can be replayed after each one.
**Non-zero length byte on a short residue.** The three unsigned counters underflow — `2 - 8` becomes `0xFFFFFFFA` — and the walk continues past the packet buffer, reading until it faults or meets a zero length byte and freezes. The Router Advertisement counter is signed and exits cleanly in this case.
**One-byte residue.** The walker reads a two-byte option header, over-reading one byte.
During a runaway walk, stray bytes parsing as a link-layer address option are copied into the neighbor cache (`nx_icmpv6_process_ns.c:280, :293`) and subsequently used as the destination MAC for frames to that neighbour, placing off-packet memory on the link. Confirmed by inspection, not reproduced. |
| Improper neutralization of special elements in data query logic in the GridFS component of the MongoDB Go Driver can cause a caller-supplied structured file identifier to be interpreted as a query condition rather than as a literal identifier. An authenticated user who can influence the identifier passed by an affected application may cause all GridFS file chunks in the affected bucket to be removed, rendering stored file content unreadable. |
| Axios is a promise-based HTTP client for the browser and Node.js. From 1.12.0 until 1.20.0, ResolveConfig reads inherited Symbol.toStringTag, append, and getHeaders properties while resolving FormData headers. A separate same-process prototype-pollution flaw supplies an array or non-plain class instance whose inherited properties make it appear FormData-like; plain objects are blocked. The inherited getHeaders function can return attacker-controlled headers that resolveConfig merges into a fetch adapter request. Attacker-controlled headers can alter authorization, cache, metadata-service, or application-specific request behavior. This issue is fixed in version 1.20.0. |
| SGLang contains a DoS vulnerability caused by missing input validation for AUX_DATA ZeroMQ control messages in the Decode worker, which enables an unauthenticated remote attacker with network reachability to the Decode control PULL socket to terminate the Decode control thread and cause a denial of service against the target server. |
| Netty is a network application framework for development of protocol servers and clients. In netty-handler prior to versions 4.1.135.Final and 4.2.15.Final, an attacker can bypass IPv6 subnet rules due to an incorrect masking operation in IpSubnetFilterRule.compareTo(). Valid public IP addresses can bypass the restrictions. Versions 4.1.135.Final and 4.2.15.Final patch the issue. |
| A vulnerability has been identified in WTV676-HB6035 Web Interface (All versions < V3.94), WTV776-HB6035 Web Interface (All versions < V4.17). Affected devices do not properly validate input received from backend services.
This could allow an unauthenticated remote attacker to force the device into protection mode, which results in losing remote connectivity functions (Web Access). |
| A vulnerability in the web UI of Cisco IOS Software could allow an authenticated, remote attacker with low privileges to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper input validation. An attacker could exploit this vulnerability by sending a crafted URL in an HTTP request. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| Multiple flaws have been identified in `named` related to the handling of DNS messages whose CLASS is not Internet (`IN`) — for example, `CHAOS` or `HESIOD`, or DNS messages that specify meta-classes (`ANY` or `NONE`) in the question section. Specially crafted requests reaching the affected code paths — recursion, dynamic updates (`UPDATE`), zone change notifications (`NOTIFY`), or processing of `IN`-specific record types in non-`IN` data — can cause assertion failures in `named`.
This issue affects BIND 9 versions 9.11.0 through 9.16.50, 9.18.0 through 9.18.48, 9.20.0 through 9.20.22, 9.21.0 through 9.21.21, 9.11.3-S1 through 9.16.50-S1, 9.18.11-S1 through 9.18.48-S1, and 9.20.9-S1 through 9.20.22-S1. |
