| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
eth: ice: don't dereference pointers from TP_printk()
After forwarding net-next during the v7.3 merge window we started
seeing:
TRACE EVENT ERROR: Event ice_tx_dim_work has double dereference in TP_printk: REC->q_vector->tx.tx_ring->q_index
WARNING: kernel/trace/trace_events.c:420 at test_double_dereference.cold+0x39/0x4b
this is due to extra checks added in tracing subsystem in
commit b5cc230af5e5 ("tracing: Warn when an event dereferences a pointer in TP_printk()").
Printing happens long after the event was recorded, by which point
the pointers may be invalid (the ring or the dim instance).
Copy the eight scalars into the event instead. |
| In the Linux kernel, the following vulnerability has been resolved:
virtio_ring: fix stale descriptor flags after a failed packed add
In a packed ring the AVAIL and USED bits sit in the descriptor itself,
so writing them makes that descriptor available. Those bit combinations
flip meaning on every round of the ring, tracked by a wrap counter, so
invalidating or validating a descriptor means inverting both bits.
Commit 1ce9e6055fa0 ("virtio_ring: introduce packed ring support") has
virtqueue_add_packed() make every descriptor of a chain available as it
maps the chain, and write the head last. The device consumes the ring in
order and stops at a head that is not available yet, so it never reaches
the rest.
When vring_map_one_sg() fails partway, unmap_release unmaps the segments
and restores avail_used_flags, but the descriptors it wrote to in the
ring stay marked with AVAIL and USED bits. The head is now the only
entry that keeps the device from consuming these stale entries.
For example, the ring would look like this now.
Z - pre-previous command
A - previous command
B - aborted command
C - current command
[A1 DONE] [A2 DONE] <C1 EMPTY> [B2] [B3] [Z1 DONE]
When the driver now attempts to issue the C command, the next add starts
at the same head as B. If C spans less descriptors than B, there is no
end marker because AVAIL and USED bits were still in place. And that
means the device will start interpreting these stale entries (B2/B3) as
another command entry, which then blocks the queue.
This effect typically happens in swiotlb configurations under memory
pressure, because vring_map_one_sg() can then fail with larger I/O
requests which then leads to command abortions.
There are broadly 2 ways to avoid leaving those flags behind:
1) Defer those flags too until the chain is complete.
2) Rewrite those flags for the previous wrap counter.
Implement the second option in both packed add paths. The first option
traverses the chain a second time on every successful add. The second
option invalidates all added descriptors when any add fails.
With this patch applied, a packed virtqueue keeps completing requests
after a failed add. |
| An issue in Kilo Code before v7.4.1 allows a local attacker to execute arbitrary code via the permission/allow-everything endpoint |
| NVIDIA GPU Display Driver for Windows and Linux contains a vulnerability in the kernel mode layer where improper cleanup of reference counts during error paths could lead to a use-after-free condition. A successful exploit of this vulnerability might lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| In the Linux kernel, the following vulnerability has been resolved:
vduse: return compat ioctl results directly
The compat handler handles VDUSE_IOTLB_GET_FD and VDUSE_VQ_GET_INFO, but
then calls the native handler. Their different command sizes make native
dispatch return -ENOIOCTLCMD.
For GET_FD, this overwrites receive_fd()'s return value after the
descriptor is installed, leaking one fd per call. Return handled compat
results directly and use native dispatch only for other commands. |
| In the Linux kernel, the following vulnerability has been resolved:
ACPI: platform: Use acpi_bus_get_primary_device()
The acpi_get_first_physical_node() usage in acpi_platform_fill_resource()
and acpi_create_platform_device() is generally unsafe because in theory
the device returned by it may be freed at any time [1].
It is also inefficient because acpi_get_first_physical_node() is called
multiple times for the same argument which can be avoided.
Address these issues by using acpi_bus_get_primary_device() instead of
acpi_get_first_physical_node() and adjusting the code to call it just
once at the beginning of and acpi_create_platform_device() and drop
the device reference acquired by it upon the return from that function. |
| A flaw has been found in OpenSC up to 0.27.1. The impacted element is the function setcos_construct_fci_44 of the file src/libopensc/card-setcos.c. Executing a manipulation of the argument type_attr can lead to stack-based buffer overflow. The attack can be launched remotely. This patch is called ad730304052937c32b4eb489a06835ac6123632c. It is best practice to apply a patch to resolve this issue. |
| A weakness has been identified in ZongXR SuperMarket 1.0.0.0. This affects the function startBuy of the file instant-buy/src/main/java/com/supermarket/instantbuy/controller/InstantBuyController.java of the component Instant Buy. Executing a manipulation of the argument Username can lead to missing authentication. The attack may be performed from remote. The exploit has been made available to the public and could be used for attacks. The project was informed of the problem early through an issue report but has not responded yet. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (corsair-cpro) Create debugfs entries after hwmon registration
ccp_debugfs_init() registers debugfs files whose private data is the devm
allocated ccp. It runs before hwmon_device_register_with_info(), so when
that registration fails, ccp_probe() returns with the files still in
place. The HID core then frees ccp, and ccp_remove() is not called for a
failed probe, so nothing removes them later either. Reading one of the
files dereferences the freed pointer.
Create the debugfs entries only after the hwmon device has been
registered, so no failing path can leave them behind.
The two version queries stay where they are. They send USB commands
without holding ccp->mutex, which is only safe as long as nothing else
can call send_usb_cmd(); once the hwmon device is registered its
callbacks can do so concurrently. Only the debugfs creation moves, and
it is told which queries succeeded. |
| Improper Access Control in ArgusMonitor.sys in Argotronic eGbR ArgusMonitor 7.4.02 and earlier allows local, low-privileged users to bypass device handle access restrictions via a TOCTOU condition in IRP_MJ_CREATE and send a crafted IOCTL 0x9C4024A8 request, causing denial-of-service. |
| In the Linux kernel, the following vulnerability has been resolved:
vduse: validate virtqueue alignment
vduse_validate_config() only checks the upper bound of vq_align. Invalid
values can therefore reach vring_create_virtqueue_map(). The split-ring
helpers use align - 1 as a bit mask, so the alignment must be a non-zero
power of two. A zero value makes vring_size() drop the descriptor and
available-ring part and vring_init() leave the used ring pointer NULL.
The VIRTIO spec requires the used ring to start at an address
aligned to at least 4 bytes. Reject values below VRING_USED_ALIGN_SIZE as
well as non-power-of-two values before they reach the virtio ring helpers.
Opening a virtio-net device created with vq_align=0 triggered:
BUG: KASAN: null-ptr-deref in virtqueue_kick_prepare_split+0xe3/0x100
Read of size 2 at addr 0000000000000000 by task systemd-network/1062
Call Trace (relevant frames):
dump_stack_lvl
print_report
kasan_report
__asan_load2
virtqueue_kick_prepare_split+0xe3/0x100
virtqueue_kick_prepare+0x40/0x60
try_fill_recv+0x857/0x1250
virtnet_open+0x189/0x460
__dev_open+0x225/0x390
__dev_change_flags+0x368/0x3b0
netif_change_flags+0x56/0xc0
do_setlink.isra.0+0x68c/0x1e30
Validate the value before it reaches the virtio ring helpers. |
| In the Linux kernel, the following vulnerability has been resolved:
vhost-vdpa: protect config_ctx from being freed under the config callback
vhost_vdpa_config_cb() loads v->config_ctx and signals it without taking
a reference and without holding any lock:
struct eventfd_ctx *config_ctx = v->config_ctx;
if (config_ctx)
eventfd_signal(config_ctx);
VHOST_VDPA_SET_CONFIG_CALL replaces that field and drops what is normally
the last reference to the old context:
swap(ctx, v->config_ctx);
if (ctx)
eventfd_ctx_put(ctx);
eventfd_ctx_put() drops the last kref and frees the context immediately,
with no RCU grace period, so a callback that has already loaded the
pointer goes on to dereference freed memory. The two sides share no
lock: the ioctl runs under vhost_dev.mutex, while the parent invokes the
callback from its own interrupt or workqueue context.
This is not the reopen refcount underflow fixed by commit f6bbf0010ba0
("vhost-vdpa: fix use-after-free of v->config_ctx"), which was about
vhost_vdpa_config_put() leaving a stale pointer behind. Here the pointer
is maintained correctly and it is the read side that is unprotected.
With VDUSE as the parent this is reachable from userspace with access to
/dev/vduse (root by default). VDUSE_DEV_INJECT_CONFIG_IRQ queues
dev->inject, and vduse_dev_irq_inject() runs the callback under VDUSE's
own dev->irq_lock, which vhost does not hold. vduse_dev_reset() does
flush_work(&dev->inject), but VHOST_VDPA_SET_CONFIG_CALL never goes
through reset, so an inject already in flight is not waited for. A
process that injects config interrupts on the VDUSE fd while another
thread swaps the call fd on the vhost-vdpa fd hits it in seconds:
BUG: KASAN: slab-use-after-free in native_queued_spin_lock_slowpath
Read of size 4 at addr ffff888107d21808 by task kworker/u17:1/2993
Workqueue: vduse-irq vduse_dev_irq_inject
Call Trace:
native_queued_spin_lock_slowpath+0x97/0x5b0
_raw_spin_lock_irqsave+0xd4/0xe0
eventfd_signal_mask+0x69/0x120
vhost_vdpa_config_cb+0x34/0x50
vduse_dev_irq_inject+0x46/0x60
process_one_work+0x468/0x950
Allocated by task 2992:
do_eventfd+0x50/0x200
__x64_sys_eventfd2+0x2e/0x40
Freed by task 2992:
eventfd_ctx_put+0xb9/0xc0
vhost_vdpa_unlocked_ioctl+0x116c/0x2190
Add a spinlock covering every access to config_ctx, so the callback
either signals a context that is still alive or observes NULL, and the
put happens only once no callback can reach the old value.
Clearing the parent's callback before the put would not be enough: of the
in-tree set_config_cb() implementations only VDUSE takes a lock, the rest
store the pointer unlocked, so that would not order against an in-flight
invocation. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix transaction overflow during writeback
Commit 95ad8ee45cdb ("ext4: correct the reserved credits for extent
conversion") was correct to note that we need to reserve enough credits
for all extents possibly underlying a large folio. However it was too
eager to reduce the number of reserved credits. Extent conversion may
not only need to touch several leaf extent blocks, it may also need to
split extents - for example a single large unwritten extent may need to
be split into many small written ones in case of sparse folio dirtying.
This can thus result not only in extent leaf modifications but also in a
need to allocate new extent tree nodes. As a result the reserved
transaction credits were not sufficient in some corner cases. Use
ext4_meta_trans_blocks() for correct upper bound credit estimate. |
| NVIDIA GPU Display Driver for Windows and Linux contains a vulnerability where an unprivileged user could cause a use-after-free. A successful exploit of this vulnerability might lead to code execution, escalation of privileges, data tampering, denial of service, and information disclosure. |
| NVIDIA GPU Display Driver for Linux contains a vulnerability in the open-source kernel module where an unprivileged local user could cause improper preservation of memory access permissions during DMA mapping. A successful exploit of this vulnerability might lead to code execution, escalation of privileges, denial of service, information disclosure, and data tampering. |
| NVIDIA vGPU Virtual GPU Manager for Linux contains a vulnerability where an attacker could cause incorrect resource transfer between spheres. A successful exploit of this vulnerability might lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| NVIDIA GPU Display Driver for Linux contains a vulnerability in the kernel mode layer where a user could cause a NULL pointer dereference. A successful exploit of this vulnerability might lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| NVIDIA GPU Display Driver for Windows and Linux contains a vulnerability in the kernel mode layer where an unprivileged user could cause an out-of-bounds write. A successful exploit of this vulnerability might lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| NVIDIA GPU Display Driver for Linux contains a vulnerability in the kernel mode layer where an unprivileged user could bypass an authorization check and modify privileged configuration. A successful exploit of this vulnerability might lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| NVIDIA GPU Display Driver for Windows and Linux contains a vulnerability in the firmware where an attacker could cause improper input validation. A successful exploit of this vulnerability might lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
